Effect of algae acclimation to the wastewater medium on the growth kinetics and nutrient removal capacity.

Algal treatment methods have been widely used in nutrient removal studies. However, in most cases, the experimental conditions have not been fully complied with actual conditions. For instance, the effect of algae acclimation to wastewater medium on cell growth and removal efficiency has generally been ignored in laboratory scale experiments. This paper investigates the effect of acclimation on cell growth and nutrient uptake rates of Arthrospira platensis and Chlorella vulgaris. For this purpose, batch reactors, which contained the synthetic secondary effluent, had been inoculated by acclimated algae cells and the growth parameters were measured daily, as well as nutrient concentration. A significant decrease (P < 0.05) in chlorophyll-a content of acclimated A. platensis was observed, although there was no significant change in specific growth rate (µ) and doubling time (dt), in comparison with the non-acclimated ones. Moreover, the acclimation process changed the chlorophyll-a content and kinetic parameters of Chlorella vulgaris. Furthermore, t test results showed a significant increase in removal rate of nitrogen compounds through the acclimation. Residence time of A. platensis and C. vulgaris was also reduced through the acclimation by approximately 50% and 25%, respectively.

Biodegradation of Cibacron Blue 3GA by insolubilized laccase and identification of enzymatic byproduct using MALDI-ToF-MS: Toxicity assessment studies by Daphnia magna and Chlorella vulgaris.

The presented paper describes a detailed study on the use of immobilized laccase for effective degradation of Cibacron Blue 3GA dye. The amount of laccase loading on the cyclic carbonate groups containing poly(hydroxyethyl methacrylate-co-vinylene carbonate), p(HEMA-co-VC), microbeads was 27.8 mg g-1, and the retained immobilized enzyme activity was 73% compared to free enzyme. The toxicity of the dye and its byproducts were studied using Daphnia magna as test organism. The micro-algal growth inhibition was also studied using a green micro algae "Chlorella vulgaris". MALDI-ToF-MS was used to verify dye degradation byproducts. After 60 min of incubation period, Cibacron Blue 3GA (CB3GA) and its byproducts disappeared from the medium. After 60-min enzymatic treatment, the non-toxic nature of medium was confirmed by toxicity studies. On the other hand, the initial byproducts of the dye seemed to be more toxic than the later formed dye products. It should be noted that the information obtained from this study can be beneficial for understanding the initial degradation byproducts toxicities of the enzymatically treated dyes to provide information about environmental protection.

Aminopyridine modified Spirulina platensis biomass for chromium(VI) adsorption in aqueous solution.

Chemical modification of Spirulina platensis biomass was realized by sequential treatment of algal surface with epichlorohydrin and aminopyridine. Adsorptive properties of Cr(VI) ions on native and aminopyridine modified algal biomass were investigated by varying pH, contact time, ionic strength, initial Cr(VI) concentration, and temperature. FTIR and analytical analysis indicated that carboxyl and amino groups were the major functional groups for Cr(VI) ions adsorption. The optimum adsorption was observed at pH 3.0 for native and modified algal biomasses. The adsorption capacity was found to be 79.6 and 158.7 mg g(-1), for native and modified algal biomasses, respectively. For continuous system studies, the experiments were conducted to study the effect of important design parameters such as flow rate and initial concentration of metal ions, and the maximum sorption capacity was observed at a flow rate of 50 mL h(-1), and Cr(VI) ions concentration 200 mg L(-1) with modified biomass. Experimental data fitted a pseudo-second-order equation. The regeneration performance was observed to be 89.6% and 94.3% for native and modified algal biomass, respectively.

Study of polyethyleneimine- and amidoxime-functionalized hybrid biomass of Spirulina (Arthrospira) platensis for adsorption of uranium (VI) ion.

This study investigates the potential application of the polyethyleneimine- (PEI) and amidoxime-modified Spirulina (Arthrospira) platensis biomasses for the removal of uranium ion in batch mode using the native biomass as a control system. The uranium ion adsorption was also characterized by attenuated total reflectance Fourier transform infrared (ATR-FTIR) spectra, zeta potential analysis, and surface area measurement studies. The effects of pH, biomass amount, contact time, initial uranium ion concentration, and ionic strength were evaluated by using native and modified algal biomass preparations. The uranium ion removal was rapid, with more than 70% of total adsorption taking place in 40 min, and equilibrium was established within 60 min. From the experimental data, it was found that the amount of adsorption uranium ion on the algal preparations decreased in the following series: amidoxime-modified algal biomass > PEI-modified algal biomass > native algal biomass. Maximum adsorption capacities of amidoxime- and PEI-modified, and native algal biomasses were found to be 366.8, 279.5, and 194.6 mg/g, respectively, in batchwise studies. The adsorption rate of U(VI) ion by amidoxime-modified algal biomass was higher than those of the native and PEI-modified counterparts. The adsorption processes on all the algal biomass preparations followed by the Dubinin-Radushkevitch (D-R) and Temkin isotherms and pseudo-second-order kinetic models. The thermodynamic parameters were determined at four different temperatures (i.e., 15, 25, 35, and 45 °C) using the thermodynamics constant of the Temkin isotherm model. The ΔH° and ΔG° values of U(VI) ion adsorption on algal preparations show endothermic heat of adsorption; higher temperatures favor the process. The native and modified algal biomass preparations were regenerated using 10 mM HNO3. These results show that amidoxime-modified algal biomass can be a potential candidate for effective removal of U(VI) ion from aqueous solution.

Immobilization of tyrosinase on modified diatom biosilica: enzymatic removal of phenolic compounds from aqueous solution.

Acid and plasma treated diatom-biosilica particles, were modified with 3-aminopropyl triethoxysilane (APTES), and activated with glutaraldehyde. Then, tyrosinase was immobilized onto the pre-activated biosilica by covalent bonding. The biosilica properties were determined using SEM, and FTIR. The enzyme system has been characterized as a function of pH, temperature and substrate concentration. Optimum pH of the free and immobilized enzyme was found to be pH 7.0. Optimum temperatures of the free and immobilized enzymes were determined as 35 and 45 °C respectively. The biodegradation of phenolic compounds (i.e., phenol, para-cresol and phenyl acetate) has been studied by means of immobilized tyrosinase in a batch system. The immobilized tyrosinase retained about 74% of its original activity after 10 times repeated use in the batch system. Moreover, the storage stability of the tyrosinase-biosilica system resulted excellent, since they maintained more than 67% of the initial activity after eighth week storage. Highly porous structure of biosilica can provide large surface area for immobilization of high quantity enzyme. The porous structure of the biosilica can decrease diffusion limitation both substrate phenols and their products. Finally, the immobilized tyrosinase was used in a batch system for degradation of three different phenols.

Biosorption of Cr(VI) by free and immobilized Pediastrum boryanum biomass: equilibrium, kinetic, and thermodynamic studies.

BACKGROUND AND PURPOSE: The biosorption of Cr(VI) from aqueous solution has been studied using free and immobilized Pediastrum boryanum cells in a batch system. The algal cells were immobilized in alginate and alginate-gelatin beads via entrapment, and their algal cell free counterparts were used as control systems during biosorption studies of Cr(VI). METHODS: The changes in the functional groups of the biosorbents formulations were confirmed by Fourier transform infrared spectra. The effect of pH, equilibrium time, initial concentration of metal ions, and temperature on the biosorption of Cr(VI) ion was investigated. RESULTS: The maximum Cr(VI) biosorption capacities were found to be 17.3, 6.73, 14.0, 23.8, and 29.6 mg/g for the free algal cells, and alginate, alginate-gelatin, alginate-cells, and alginate-gelatin-cells at pH 2.0, which are corresponding to an initial Cr(VI) concentration of 400 mg/L. The biosorption of Cr(VI) on all the tested biosorbents (P. boryanum cells, alginate, alginate-gelatin, and alginate-cells, alginate-gelatin-cells) followed Langmuir adsorption isotherm model. CONCLUSION: The thermodynamic studies indicated that the biosorption process was spontaneous and endothermic in nature under studied conditions. For all the tested biosorbents, biosorption kinetic was best described by the pseudo-second-order model.

The study of heavy metal pollution and accumulation in water, sediment, and fish tissue in Kizilirmak River Basin in Turkey.

The accumulation of heavy metals such as Pb, Hg, Co, Cr, Cu, Zn, and Br were determined in water, sediment, muscle, and gill of three fish species (Leuciscus cephalus, Capoeta tinca, Capoeta capoeta) which were collected in Kizilirmak River Basin (Delice River). The metal concentration showed a general trend of Br>Zn>Pb>Cr>Cu>Hg>Co in water and Cr>Zn>Pb>Cu>Co>Hg>Br in sediment samples while Zn>Cu>Pb>Br>Cr>Hg>Co were in muscle and Zn>Pb>Cu>Cr>Br>Hg>Co were in the gill tissue.